XR-S and XR-D Controls
A Complete System Consists of the Following:
- XR-Control
- XR push-pull gun
- Recommended 14-pin
- Miller power source
Download PDF
A Complete System Consists of the Following:
True push-pull wire feeder. Slave/torque motor provides continuous push force to the wire while the gun motor controls wire feed speed at the arc, together providing accurate and positive wire feed speed over long distances (up to 35 ft).
Run-in control can be adjusted to tune arc starting, reducing wire stubbing or arc flaring which can result in burnbacks to the contact tip.
Wire jog control allows wire to be threaded through gun cable without energizing weld output.
Trigger hold reduces fatigue by allowing operator to make long welds without holding trigger
| Input Power | 24 VAC, 5 A, 50/60 Hz |
|---|---|
| Input Welding Circuit Rating | 400 A at 100% Duty Cycle (System duty cycle is limited to gun rating.) |
| Wire Speed | 70 –780 IPM (1.8 – 22.2 m/min) |
| Wire Diameter Range | Aluminum: .035 –.062 in (0.9 –1.6 mm) Solid Wire: .035 –.045 in (0.9 –1.2 mm) Drive roll kit #195 591 required to run 1/16 in (1.6 mm) wire |
| Maximum Spool Size Capacity | 12 in (305 mm) |
| Dimensions | H: 16 in (406 mm) W: 9-1/2 in (241 mm) D: 21-1/4 in (540 mm) |
| Net Weight | 42.5 lb (19.2 kg) |